Pay in 4 interest-free payments of $14.25 Learn more
Ships within 48 hours · Estimated delivery Sep 13 - Sep 18
This is a replacement connector for TB2 on the DSI board
The factory default is PNP
Load short-circuit protection Ambient temperature range Operation and storage: 25 to 70 degrees C (with no icing or condensation) Ambient humidity range Operation and storage: 35% to 95% (with no condensation) Temperature influence +/- 15% max
) Reversed power polarity protection Yes Output short circuit protection Yes Reversed output polarity protection Yes Response time Operate or reset: 2 ms max
Sensor Connector (for DSI 2 front Panel) Connection Hardware & Accessories This is a replacement connectorThe SV 40 Male connector is used when you want to connect an individual sensor to the DSI 2 front panel. These connectors should be soldered to the sensor cable end. The sensor wiring is as follows: Pin #1 +24V Sensor Power (Brown wire) Pin #2 Power Return Ground (Blue wire) Pin #3 Sensor Signal Wire (Black or white wire)
US$ 79.00
US$ 197.00
US$ 114.00
US$ 122.00
