Pinbetween sensor If you need a smaller/closer

If you need a smaller/closer range

but you can still use the original Inky pHAT Python library if you have one of these original boards

This board/chip uses I2C 7-bit address between 0x3C-0x3D

interne Kickback-Schutzdioden

Pinbetween sensor If you need a smaller/closerThe 40 pin male header on Pinbetween lets you use jumper jerky to connect extra bits to your micro: bit while using an edge connector add on like the enviro: bit, for example. Plug your micro: bit into the edge connector at the top, attach your micro: bit add on at the bottom, and then use the handily grouped and labelled pins in between for whatever you wish! Note: micro: bit, enviro: bit, breadboard, etc. pictured are not included! Features Comes